Fiberglass

Posted By :
Comments : Off

SURFACE PREPARATION

Degrease the surface with our antisilicone solvent SOLVENTE 102 and then sand it with medium sandpaper (n. 120-140).

HULL
- Apply one coat of FIBERGLASS PRIMER and wait at least 4 hours (at 20° C)
- Apply one coat of antifouling and wait at least 6 hours (at 20° C)
- Apply a second coat of antifouling and wait at least 24 hours (at 20° C) before launching It is advisable to apply a third coat of antifouling on the water line.

TOPSIDE
- Apply one coat of EPOPLASTIC and wait at least 12 hours (at 20° C)
- Sand the surface with medium sandpaper (n.150-180)
- Apply a second coat of EPOPLASTIC and wait at least 12 hours (at 20° C)
- Sand the surface with medium-fine sandpaper (n.180-220)
- Apply one coat of polyurethane enamel EVERGLOSS and wait at least 6 hours (at 20° C)
- Water sand the surface with fine sandpaper (n.240-280)
- Apply a second coat of polyurethane enamel EVERGLOSS If the surface is in good conditions sand with medium-fine sandpaper and then apply two coats of EVERGLOSS enamel directly on the gelcoat. Also, if the two coats of EVERGLOSS are applied within 8 hours, there is no need to sand between coats. However, in order to eliminate any eventual imperfection from the first coat, such as dust or insects, it is advisable to slightly water sand the surface with fine sandpaper (n.240-280).

INNER NON VISIBLE PARTS
Sand the surface with coarse sandpaper (n.80-100), and then apply two coats of EPOGEL. This product has also the property of stopping the bad smells of new fibreglass.