|
  
       
     
|
PAINTING STEEL BOATS
Remove
rust and scales from the surface through sandblasting. Remove dust using a
dry cloth or an air jet (do not use any solvent otherwise adhesion of the
following coat can be impaired). If necessary degrease the surface with
our antisilicone solvent SOLVENTE 102 before sandblasting.
Apply
one coat of PRIMEPOX. It is advisable to apply this product with a brush,
as this would facilitate the absorption of the product into the pores and
the amalgamation of eventual impurities with the film.
Where
necessary apply one or more coats of our EPOXY FILLER, without sanding
between the coats if they are applied within 16 hours from each other (at
20° C).
After
this stage the painting cycle changes depending on the part of the boat we
wish to paint.
HULL
-
Sand
with coarse sandpaper (n.100-120)
-
Apply
two or three coats of ROSTAR (coal-tar epoxy anticorrosive paint) with a
total consumption of 0,5 litres per square meter. For a
good adhesion it is necessary to apply the coats within 24 hours from
each other (at 20° C), during summer this interval will be between 12
and 16 hours. Note
that this product can be replaced with our epoxy solventless protective
coating BARRIER. After applying BARRIER the surface must be sanded with
medium sandpaper (n.150-180).
-
Apply
one coat of FIBERGLASS PRIMER (consumption: 12 square meter per liter)
-
Apply
two coats of our antifouling SUPER 505, or MARLIN TF, or MAXIMA
(consumptoion: 8 square meter per liter per coat).
TOPSIDE
-
Sand
the surface with medium sandpaper (n.120-150)
-
Apply
one or two coats of our epoxy coating EPOPLASTIC AS (consumption: 8
square meters per liter per coat).
-
After at
least 24 hours at 20° C sand
the surface with sandpaper n.200-240
-
Apply
two coats of our polyurethanic enamel EVERGLOSS (consumption: 8 square
meters per liter per coat by brush, 20-30% more by spraygun). No sanding
is necessary if the two coats are applied between 6 and 8 hours.
BILGES AND INDOOR PARTS
|
